Sliding Gate Hardware Kit - Bolt Down Track

Electric Gate Hardware Kits
Select Your Complete Electric Sliding Gate Hardare Kit - Bolt Down Track

Our sliding gate hardware kits listed below include everything you will need for a manual sliding gate including bolt down track. Couple this with our industry leading sliding automation kits and its never been easier to automate a sliding gate.

Sliding Hardware Kit Contains:

• 1] Bump Stop (Stops the gate running off the end during opening.)
• 2] C Channel Rollers (48 x 15mm with bearing)
• 3] C Channel (50 x 30mm Galvanised)
• 4] Rollers (Gate Rollers 80 or 90mm)
• Floor Track (Bolt Down 6])
• 7] Meeting Point (Gate closing stop)

          Optional Extras

• C Channel Mounting Post​ - 75mm x 75mm x 1850mm

Choosing the Correct Kit: To find the correct kit there are two steps, firstly you must know the correct opening width. The Electric Gate Shop has already accounted for overhang, so the only measurements you need is the opening between the posts.

Firstly, choose the size opening number from the list:

[1] 1200 - 1750mm Opening
[2] 1750 - 2600mm Opening
[3] 2600 - 3650mm Opening
[4] 3650 - 5500mm Opening
[5] 5500 - 7450mm Opening
[6] 7450 - 8600mm Opening
[7] 8600 - 9500mm Opening

Now, the requirements for your gate:

[B] As above but with Boltdown floor track replacing Concrete in floor track, C Channel and rollers to support the gate.
[D] As kit (B) but the C Channel & C Rollers are replaced with 2 of 40 x 45mm Nylon support rollers.Now combine both the number and letter to find your hardware kit.

e.g  A full Sliding Gate Hardware Kit (SGHK - 3A) using concrete in floor track for a gate opening of 2700mm between the posts would be kit (3A)



 

PDF - Sliding Factsheet

Technical Information

Our sliding gate hardware kits listed below include everything you will need for a manual sliding gate. Couple this with our industry leading sliding automation kits and its never been easier to automate a sliding gate.

Sliding Hardware Kit Contains:

• 1] Bump Stop (Stops the gate running off the end during opening.)
• 2] C Channel Rollers (48 x 15mm with bearing)
• 3] C Channel (50 x 30mm Galvanised)
• 4] Rollers (Gate Rollers 80 or 90mm)
• Floor Track (Concrete 5] or Bolt Down 6])
• 7] Meeting Point (Gate closing stop)

          Optional Extras

• C Channel Mounting Post​ - 75mm x 75mm x 1850mm