ARMAS/FERPORT No Touch Safety Edge and Controller

No Touch 2 Infrared Safety Edge that allows for up to 3 beams to be connected for full protection of trap areas with an optical range of 8 meters.

Starter Kit Includes:
1 x No Touch Controller
1 x 2m Edge Backing Strip
1 x 2m Edging Rubber
1 x TX Transmitter Lens
1 x RX Receiver Lens

Infrared technology allows for the edge control system to recognize an obstacle before it comes into physical contact with said object allowing for no direct contact and allowing for minimal trapping.

Used as a safety device for many different types of installation including gates, garage doors and many others. Ensure that when mounting No Touch on an automated gate the TX Bulb is mounted at the bottom of the gate and the RX is mounted at the top. See Image below.

No Touch allows for edges to be mounted on multiple edges of automation using 90° adapters that allow for easy mounting. See Image Below.

Technical Characteristics:
Power Supply - 12/24v AC/DC
Consumption 1 beam 12v - 55mA DC
Consumption 2 beam 12v - 62mA DC
Consumption 3 beam 12v - 70mA DC
Consumption 1 beam 24v - 39mA AC/DC
Consumption 2 beam 24v - 54mA AC/DC
Consumption 3 beam 24v - 60mA AC/DC
Wave Length - 880nm
Relay - 1 A at 24v AC
Test Control Board - 12/24v AC/DC
Optical Range - 8m (6m Recommended)
Relay Response Time - 10ms

No Touch 2 System is in compliance with EN 12453 - EN 12445 safety regulations.
Print Page