> Gate Safety Edges

Electric Gate Safety Edges.

New in stock, our gate safety edge section. 

Safety contact edges or rib edges as commonly known are used to guard against possible crushing or shearing points on electric gates and barriers. They can be used on sliding and swing gates at any point where movement and the risk of crushing needs to be addressed. 

    

CCE are CE marked and manufactured in Italy. They comply to EN12978/2003-2005 and EN ISO13849-2
Our Wireless Safety Edge
system can be used so that the active rubber edge is carried on the gate itself and the cut off signal is carried to the main controller wirelessly. Compliance with gate and door standard EN-13241-1:2003 and EN12453, certified by approved laboratory to EN-954-1 standard, Cat. 2

The Electric Gate Shop are committed to keeping these prices low.  This is to encourage their full use by everyone installing electric gate equipment so there is no excuse for any compromise on safety.

Gate Safety Edges
aso indus cat 3 signal transmission system
ASO Indus Cat 3 Signal Transmission System
Click to read more
FROM: £9999.00
(Ex VAT £8332.50)
safety edge hinge protection, passive rubber strip. made in italy to eu standards.
Safety Edge Hinge Protection, passive rubber strip. Made in Italy to EU standards.
Click to read more
FROM: £150.00
(Ex VAT £125.00)
Proglide Complete 'Futureproof' solution for moving edges. Includes Transmission System and 2 Edges
Proglide Complete 'Futureproof' solution for moving edges. Includes Transmission System and 2 Edges
Click to read more
FROM: £295.00
(Ex VAT £245.83)
sliding gate wired safety edge, indus trial safety edge system.
Sliding Gate wired safety edge, industrial safety edge system.
Click to read more
FROM: £420.00
(Ex VAT £350.00)